Home > News > Content
Products Categories
Contact Us

ADDRESS:Fukang Road, Dainan Town, Xinghua City,Jiangsu Province, China
MOBILE:+8615861083672
TEL:+86-523-80218064
E-MAIL:davidwirerope@yasten.cn

Trolley Steel Wire Rope Use Precautions
Jun 27, 2017

1. Steel Wire Rope shall not be bent, shall not be stained with oil, debris, shall not have slag and ablation phenomenon, is strictly prohibited work Steel Wire Rope, safety Steel Wire Rope as a low-voltage welding circuit.

2. The basket must use the specified form of the form and the mechanical properties of the Steel Wire Rope, the various hoists used in the Steel Wire Rope can not be mixed. Steel Wire Rope test and scrapped in accordance with GB5972-86 implementation, to achieve the scrapped standard Steel Wire Rope must be scrapped.

3. Steel Wire Rope should be properly maintained and maintained in the course of the use of oil can not be stored in the storage and alkaline substances and corrosive gases to avoid mixing, to prevent pollution and corrosion.

The Steel Wire Rope must be replaced immediately if one of the following conditions occurs:

A steel wire of the stock, kink, loose, flattened, bent or any other twisted, deformed.

B. The Steel Wire Rope should be scrapped when the number of yarns reaches 5 in a twist distance. When the surface of the Steel Wire Rope is worn or corroded, the standard of scrapping will be reduced. The percentage of descending will be allowed to break up to 5 at each twist. To the surface of the Steel Wire Rope wear or corrosion percentage to be reduced.

C. There are significant signs of corrosion on the Steel Wire Rope, and the surface of the pit, Steel Wire Rope relaxation.

D. The nominal diameter of the Steel Wire Rope is reduced by 6%, even if no broken wire is found.

E. When the outer wire wear reaches 40% of the end.

F. Damage or accumulation caused by heat or arc.

4. Steel Wire Rope rope must be working Steel Wire Rope and safety rope after straightening to be inserted into the hoist and safety lock, to avoid distortion or winding Steel Wire Rope.

5. Machine handling, the Steel Wire Rope should be coiled, packaged after shipment.

6. When the Steel Wire Rope is placed, the rope should be placed on the free surface, the rope will be carefully pulled out slowly along the wall after the slide down, is strictly prohibited to put the wire into a disk down. After the rope is put, the tangled rope should be carefully pressed and pressed, and the extra Steel Wire Rope on the ground should be tightly tightened and free from the ground.

How to use Steel Wire Rope for basket

1. Wear work Steel Wire Rope

Two Steel Wire Ropes located in the inner position of the front beam of the suspension are so that the working Steel Wire Rope should penetrate into the hoisting machine.

A. Before wearing a rope carefully check the Steel Wire Rope through the end of the welding head arc cone and the ball is smooth and smooth, welding at the junction of a wire head when the tip, the application file carefully Xiuhua smooth, and the wire head into the rope

B. Insert the Steel Wire Rope into the section through the roller groove on the safety lock arm and insert it into the rope at the top of the hopper. When the wire is inserted, insert the Steel Wire Rope slightly and insert it into the hoisting machine.

C. Turn the changeover switch and press the corresponding up button so that the Steel Wire Rope is automatically wound around the drive plate in the elevator.

D. When the rope is exposed, the rope should be guided by the hand to prevent the rope from colliding with the suspension platform or ground.

E. Place the piercing Steel Wire Rope through the guide pulley at the lower end of the hoist stand to place the Steel Wire Rope on the outside of the suspension platform.

F. Both ends of the hoist to wear rope to the rope when the rope can be stopped.

2. Wear safety Steel Wire Rope

Two Steel Wire Ropes on the outside of the front beam of the suspension are safety rope and should penetrate into the safety lock.

When wearing a rope, insert the Steel Wire Rope into the rope into the rope into the rope, push the hand, free through the security lock, from the safety lock below the rope out of the rope will be pulled out until the rope tightened.


Related News

Learn More Information About Our Products Know More
Copyright © Jiangsu Yasheng Metal Products Co.,Ltd All rights reserved.